Establishing of RS232 connection

1
0
-1
To find a solution for the problem I asked a colleague to measure the output at the cable. Together we looked at the hex-commands that are sent to the generator. We found out that whenever the generator measured a certain value the connection was terminated, because this value was interpreted as an end flag by the software.
  • irrelevant
  • passing knowledge
  • knowledgeable
  • expert
Total votes: 0
  • no complexity
  • simple
  • moderate
  • complex
  • very complex
Total votes: 0
Complexity
5 views.
Answer
1 answer

Establishing of RS232 connection

1
0
-1

To find a solution for the problem I asked a colleague to measure the output at the cable. Together we looked at the hex-commands that are sent to the generator. We found out that whenever the generator measured a certain value the connection was terminated, because this value was interpreted as an end flag by the software.

  • no complexity
  • simple
  • moderate
  • complex
  • very complex
Total votes: 0
Complexity